Development Center
Our state-of-the-art development center is located in Mechernich/Obergartzem near Cologne. On almost 1500 square meters we dedicate ourselves to the development of Power and Eco-optimizations, V-max coding, transmission optimization, as well as turbo and supercharger kits.
The coordination and further development of the software and hardware is carried out on a modern Super-Flow SF880 four-wheel drive high-performance dyno. This dyno has a mechanically connected roller kit, so we have each all-wheel-drive system without error messages or can measure damage to the drive train. Of course, one can also easily measure front and rear-wheel-drive vehicles. There is a braking performance measurement possible up to 1000 KW per axle to the wheel and 1200 KW per axis on the engine. It’s ideal for particularly powerful vehicles, whether with suction and turbo or supercharger engine. Due to the design of the dyno the vehicles need a minimum ground clearance of only 4 cm, which can be measured by also very deep racing and road vehicles. Also the air recirculation is impressive. It can move air masses of up to 125,000 m³/h. This corresponds to an air velocity of approximately 160 km/h.
Our extensively tested and internationally recognized software and hardware optimizations are manufactured in painstaking development work. For over 15 years we produce our software products alone. Each new development is carefully tried on the performance dyno and tested until an optimal result was achieved. This is the only way we can offer you the highest quality standards. In 2018 alone we’ve done over 1000 optimizations for passenger cars and over 500 optimizations for trucks and agricultural vehicles for satisfied customers.